Lecroy WAVEACE 2024 4-channel oscilloscope, Digital Storage oscilloscope, WaveAce 2024 사용자 설명서
제품 코드
WaveAce 2024
Operator's Manual
920836 Rev A
41
DISPLAY - HOR_POSITION, HPOS
Description
The HOR_POSITION command repositions the geometric center of a zoom to display different
portions of the trace. Allowed positions range from division 0 through 10. If the source trace
was acquired in sequence mode, the shift will only apply to a single segment at a time.
portions of the trace. Allowed positions range from division 0 through 10. If the source trace
was acquired in sequence mode, the shift will only apply to a single segment at a time.
The difference between the specified and the current horizontal position is applied to all
zooms. However, if the difference would cause any zoom trace to go outside the left or right
screen boundaries, the difference is adapted before being applied to the traces.
zooms. However, if the difference would cause any zoom trace to go outside the left or right
screen boundaries, the difference is adapted before being applied to the traces.
The HOR_POSITION? query returns the position of the geometric center of the zoom.
NOTE: Segment number 0 has the special meaning Show All Segments Unexpanded.
Command Syntax
Hor_POSition <hor_position>,<segment>
<hor_position>:= 0 to 10 DIV
<segment>:= 0 to max segments
NOTE: The segment number is only relevant for waveforms acquired in sequence mode;
it is ignored in single waveform acquisitions. When the segment number is set to 0, all
segments are shown. The unit DIV is optional.
it is ignored in single waveform acquisitions. When the segment number is set to 0, all
segments are shown. The unit DIV is optional.
Query Syntax
Hor_POSition?
Response Format
Hor_POSition <hor_position>[,<segment>]
Example
The following instruction positions the center of the zoom at division 3:
HPOS 3