Rigol DS1104B 4-channel oscilloscope, Digital Storage oscilloscope, DS1104B 사용자 설명서
제품 코드
DS1104B
RIGOL
© 2008 RIGOL Technologies, Inc.
User‟s Guide for DS1000B series
2-76
Pass/Fail
The Pass/Fail function monitors changes of signals and output pass or fail signals by
comparing the input signal which is within the pre-defined mask.
Press Utility→Pass/Fail to go to the following menu.
Figure 2-93 Table 2-58 The Pass/Fail menu (Page 1/2)
comparing the input signal which is within the pre-defined mask.
Press Utility→Pass/Fail to go to the following menu.
Figure 2-93 Table 2-58 The Pass/Fail menu (Page 1/2)
Menu
Setting
Comments
Enable Test
ON
OFF
OFF
Turn on Pass/Fail test.
Turn off Pass/Fail test.
Turn off Pass/Fail test.
Source
CH1, CH2,
CH3, CH4
CH3, CH4
Select Pass/Fail test on CH1, CH2,
CH3 or CH4.
CH3 or CH4.
Operate
(RUN)
■
(STOP)
Pass/Fail test stopped, press to run.
Pass/Fail test running, press to stop.
Pass/Fail test running, press to stop.
Msg display
ON
OFF
OFF
Turn on Pass/Fail information display.
Turn off Pass/Fail information display.
Turn off Pass/Fail information display.
Figure 2-94 Table 2-59 The Pass/Fail menu (Page 2/2)
Menu
Settings
Comments
Output
Fail
Fail +
Fail +
*
Pass
Pass+
*
Output when Fail condition detected.
Output and beep when Fail condition
detected.
Output when Pass condition detected.
Output and beep when Pass condition
detected.
Output and beep when Fail condition
detected.
Output when Pass condition detected.
Output and beep when Pass condition
detected.
Stop
on Output
on Output
ON
OFF
OFF
Stop test when output occur.
Continue test when output occur.
Continue test when output occur.
Mask Setting
Go to mask setting menu.
*Note: The beeper should be opened.