Supermicro X6DAL-XG X6DAL-XG-B 사용자 설명서

제품 코드
X6DAL-XG-B
다운로드
페이지 108
The information in this User’s Manual has been carefully reviewed and is believed to be
accurate. SUPER MICRO COMPUTER assumes no responsibility for any inaccuracies that
may be contained in this document, makes no commitment to update or to keep current the
information in this manual, or to notify any person or organization of the updates.Please
Note:  For the most up-to-date version of this manual, please see our web site at
www.supermicro.com.
SUPER MICRO COMPUTER reserves the right to make changes to the product described
in this manual at any time and without notice.  This product, including software, if any, and
documentation may not, in whole or in part, be copied, photocopied, reproduced, translated
or reduced to any medium or machine without prior written consent.
IN NO EVENT WILL SUPER MICRO COMPUTER BE LIABLE FOR DIRECT, INDIRECT,
SPECIAL, INCIDENTAL, OR CONSEQUENTIAL DAMAGES ARISING FROM THE USE OR
INABILITY TO USE THIS PRODUCT OR DOCUMENTATION, EVEN IF ADVISED OF THE
POSSIBILITY OF SUCH DAMAGES.  IN PARTICULAR, SUPER MICRO COMPUTER SHALL
NOT HAVE LIABILITY FOR ANY HARDWARE, SOFTWARE, OR DATA STORED OR USED
W I T H   T H E   P R O D U C T ,   I N C L U D I N G   T H E   C O S T S   O F   R E P A I R I N G ,   R E P L A C I N G ,
INTEGRATING, INSTALLING OR RECOVERING SUCH HARDWARE, SOFTWARE, OR
DATA.
Any disputes arising between manufacturer and customer shall be governed by the laws of
Santa Clara County in the State of California, USA.The State of California, County of
Santa Clara shall be the exclusive venue for the resolution of any such disputes.
Supermicro's total liability for all claims will not exceed the price paid for the hardware
product.
*California Best Management Practices Regulations for Perchlorate Materials: This Perchlorate
warning applies only to products containing CR (Manganese Dioxide) Lithium coin cells. "Perchlo-
rate Material-special handling may apply. See WWW.dtsc.ca.gov/hazardouswaste/perchlorate."
WARNING: Handling of lead solder materials used in this
product may expose you to lead, a chemical known to the
State of California to cause birth defects and other reproduc-
tive harm.
*FCC Statement: This equipment has been tested and found to comply with the limits for a
Class B digital device pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and
used in accordance with the manufacturer’s instruction manual, may cause interference with
radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, you are encouraged
to try to correct the interference by one or more of the following measures:
· Reorient or relocate the receiving antenna.
· Increase the separation between the equipment and the receiver.
· Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
· Consult the dealer or an experienced radio/television technician for help.
Revision Number: Rev. 1.0a
Release Date: July 30, 2007
Unless you request and receive written permission from SUPER MICRO COMPUTER, you
may not copy any part of this document.
Information in this document is subject to change without notice. Other products and
companies referred to herein are trademarks or registered trademarks of their respective
companies or mark holders.
Copyright © 2007 by SUPER MICRO COMPUTER INC.
All rights reserved.
Printed in the United States of America