Nikon AW130 VNA844E1 사용자 설명서

제품 코드
VNA844E1
다운로드
페이지 234
xi
In
• If a foreign substance adheres to the 
outside of the camera or inside of the 
battery-chamber/memory card slot 
cover (in locations such as yellow 
waterproof packing, hinges, memory 
card slot, or terminals), immediately 
remove it with a blower. If a foreign 
substance adheres to the waterproof 
packing inside of the battery-chamber/
memory card slot cover, remove it with the included brush. Do not use the 
included brush for anything other than cleaning the waterproof packing.
• If a foreign substance such as suntan oil, sunscreen lotion, hot spring, bath 
mix powder, detergent, soap, organic solvent, oil, or alcohol adheres to the 
camera, immediately wipe it off. This could cause deterioration of the 
camera exterior.
• Do not leave the camera in low temperature conditions in cold climate 
regions or in high-temperature conditions of 40°C (104°F) or more (in 
particular, a place exposed to direct sunlight, inside the cabin of a car, on a 
boat, on the beach, or near heating apparatus) for a long period of time. This 
could cause deterioration of the waterproof performance.
Before Using the Camera Underwater
Remove the strap for land use before using the camera underwater.
1. Make sure that there are no foreign substances inside the battery-
chamber/memory card slot cover.
• Any foreign substances such as sand, dust or hair inside the battery-
chamber/memory card slot cover should be removed with a blower.
• Any liquid such as water droplets inside the battery-chamber/memory 
card slot cover should be wiped off with a soft dry cloth.
2. Make sure that the waterproof packing of the battery-chamber/
memory card slot cover is not cracked or deformed.
• The waterproof performance of waterproof packing may start to 
deteriorate after one year.
If the waterproof packing begins to deteriorate, consult your retailer or 
Nikon-authorized service representative.
• Make sure that the waterproof packing is not detached from the camera.
3. Make sure that the battery-chamber/memory card slot cover is 
firmly closed.
• Rotate the battery-chamber/memory card slot cover latch until it clicks 
into place. Make sure that the thin cord of the camera strap does not get 
caught.
• Make sure that the latch indicator indicates the “Close” status.