Newstar NS-431H 사용자 설명서
7
----------------- Operations
Front Panel
On-line LED & Selected LED
When the LED turns green, the connected computer is powered-on.
When a computer is selected, its corresponding red LED illuminates.
Push-buttons
Each computer has a button associated with it on the front panel for
selection.
K/M RESET
K/M RESET solves most problems developed by keyboard, mouse,
device replacement or change of configuration. Press down both the
front-panel number 1 and 2 push buttons for 2 seconds to re-configure
the whole system without turning either the USB KVM switch or any
computer off.
AUTO SCAN
Auto Scan automatically scans through computers one by one in a
fixed interval (see Scan Time below). To initiate Auto Scanning, for
NS431H, you can press down both the front-panel number 3 and 4
buttons for 2 seconds. For NS831DH and NS1631DH, press 7 and 8
instead.
Note: For NS431H model only: computers using USB keyboard and
When the LED turns green, the connected computer is powered-on.
When a computer is selected, its corresponding red LED illuminates.
Push-buttons
Each computer has a button associated with it on the front panel for
selection.
K/M RESET
K/M RESET solves most problems developed by keyboard, mouse,
device replacement or change of configuration. Press down both the
front-panel number 1 and 2 push buttons for 2 seconds to re-configure
the whole system without turning either the USB KVM switch or any
computer off.
AUTO SCAN
Auto Scan automatically scans through computers one by one in a
fixed interval (see Scan Time below). To initiate Auto Scanning, for
NS431H, you can press down both the front-panel number 3 and 4
buttons for 2 seconds. For NS831DH and NS1631DH, press 7 and 8
instead.
Note: For NS431H model only: computers using USB keyboard and
mouse are not immediately operable when selected during Auto
Scan. Wait for about three seconds after switching to a USB
computer, and then use the keyboard and mouse.
Scan. Wait for about three seconds after switching to a USB
computer, and then use the keyboard and mouse.
8
OSD (On-Screen-Display) Operation
OSD models only
Figure 6: OSD screen illustration
By hitting the left Ctrl key twice within two seconds, you may see
the 'Hotkey Menu' if it is enabled (an OSD option). Or, by hitting the
left Ctrl key three times within two seconds, you will see a 'KVM
MENU' screen showing a list of the computers with corresponding port
numbers, names and status, see Figure 6.
The port number of the currently selected computer is displayed in red,
same as the front indicator, at the right corner of the OSD menu.
the 'Hotkey Menu' if it is enabled (an OSD option). Or, by hitting the
left Ctrl key three times within two seconds, you will see a 'KVM
MENU' screen showing a list of the computers with corresponding port
numbers, names and status, see Figure 6.
The port number of the currently selected computer is displayed in red,
same as the front indicator, at the right corner of the OSD menu.