Beurer N/A 637.05 637.05 637.05 사용자 설명서

13

•  Remove the packaging

•  Check the device, power supply and cables for damage.

• Before you plug in the foot bath, fill it up to the fill-level mark (approx 2-3 cm full) with either warm or cold 

water. 

•   Route the cable safely so that there is no risk of anyone tripping over it.

Make yourself comfortable in a chair and place your feet on the foot rest and apply slight pressure. Never 
stand up in the foot bath. The rubber feet on the base of the unit prevent it from sliding. 
The device has two massage functions:

• Function 1   : bubble massage, infrared light and water heating

• Function 2

 

 

: activation of vibration massage

- Press the   - button to switch on the bubble massage (with infrared light and water temperature control).

-   Press  the 

 -  button to switch the bubble massage (with infrared light and water temperature control) 

off again.  

These functions are only available together.

While the bubble massage with infrared light and water temperature control is running, you have the option 

to switch on the vibration massage. The vibration massage will only function when the bubble massage with 

infrared light and water temperature control is switched on. It cannot be used separately.

- Press the 

 - button to activate the vibration massage.

- Press the 

 - button to switch the vibration massage off again.

You can experience a special massage effect by moving your feet back and forth on the 2 massage rollers 

integrated into the bottom of the footbath. The massage rollers can optionally be removed by pulling them 

firmly upwards. When installing the rollers, make sure that the roller fixing points downwards, as shown in 

the illustration.

Place the chosen attachment onto the fixture provided. The brush attachment can be used to stimulate the 

reflex zones in the soles of your feet. The massage attachment provides a soothing massage for your feet 

and promotes the circulation. The corn and callus remover is used to remove dead skin cells and calluses. 

The foot bath features 16 magnets and 4 infrared light dots which are integrated into the foot tub. They help 

to boost circulation and stimulate reflexology points.

The removable aroma filter allows you to easily add bath additives such as bath crystals, bath salts etc. 
To do this, remove the filter cover 

[11] from the device by pulling it upwards. Remove the aroma filter [12]. 

Add bath products up to the level of the mark on the inside of the filter/underneath the first line of holes. 
Now attach the filter underneath the filter cover. When doing so, note the arrow marks on the filter and foot 
bath; these indicate the correct position of the filter. The two arrows must point to each other. Reattach the 
filter cover.
The filter can be easily removed and cleaned after use. Rinse the filter with clean water.
Please observe the fill-level mark on the filter and do not fill the filter above this mark.
Be aware that some bath products may create a great deal of foam when combined with the bubble massage. 
For this reason, do not leave the foot bath unsupervised and switch it off immediately if excess foam builds up.