C&E Funk-Wetterstation WS 1173 Wireless Weather Station WH 1172 데이터 시트

• Open the battery compartment on the back of the outdoor sensor by turning out the

attachment screw of the battery compartment lid.

• Insert two type AAA/Micro batteries in the battery compartment in the correct polarity

(observe plus/+ and minus/-).

• Close the battery compartment lid again.

• Open the battery compartment on the rear of the weather station and insert 3 type AA/mignon

batteries into with correct polarity (observe plus/+ and minus/-).

• Close the battery compartment again.
• The weather station display briefly shows all display segments and the display lighting will

be activated briefly.
Then the weather station searches for the outdoor sensor and the display shows
“ “.



The sensor search takes about 3 minutes; do not move the weather station and the
outdoor sensor during this period and do not push any button.

• After completion of the sensor search, the weather station will start a reception attempt for

the DCF signal; the radio tower symbol “ ” flashes in the lower side of the display.



The search for the DCF signal and assessment of the signal may take up to 10
minutes; do not move the weather station during this time and do not push any button.
If no DCF signal is recognised within 1 minute, the weather station interrupts the DCF
search and will restart it after 2 hours.
If you want to restart the DCF signal search manually, remove the batteries from the
weather station. Wait for 10 seconds and re-insert them.