Gigabyte Motherboard GA-EP35-DS4 GA-EP35-DS4 사용자 설명서
제품 코드
GA-EP35-DS4
- 51 -
BIOS Setup
2-9
MB Intelligent Tweaker(M.I.T.)
CMOS Setup Utility-Copyright (C) 1984-2007 Award Software
MB Intelligent Tweaker(M.I.T.)
KLJI: Move
Enter: Select
+/-/PU/PD: Value
F10: Save
ESC: Exit
F1: General Help
F5: Previous Values
F6: Fail-Safe Defaults
F7: Optimized Defaults
Item Help
Menu Level`
x Write To Precharge Delay
4
Auto
x Refresh to ACT Delay
20
Auto
x Read To Precharge Delay
2
Auto
x Static tRead Value
4
Auto
x Static tRead Phase Adjust 13
Auto
******** System Voltage Optimized ********
System Voltage Control
[Manual]
DDR2 OverVoltage Control
[Normal]
PCI-E OverVoltage Control
[Normal]
FSB OverVoltage Control
[Normal]
(G)MCH OverVoltage Control
[Normal]
Loadline Calibration
[Enabled]
CPU Voltage Control
[Normal]
Normal CPU Vcore
1.30000V
CMOS Setup Utility-Copyright (C) 1984-2007 Award Software
MB Intelligent Tweaker(M.I.T.)
Robust Graphics Booster
[Auto]
CPU Clock Ratio
(Note)
[25X]
CPU Frequency
3.33GHz (133x25)
CPU Host Clock Control
[Disabled]
x CPU Host Frequency (Mhz)
133
PCI Express Frequency (Mhz)
[Auto]
C.I.A. 2
[Disabled]
Performance Enhance
[Turbo]
System Memory Multiplier
(SPD)
[Auto]
Memory Frequency (Mhz)
533
533
DRAM Timing Selectable
(SPD)
[Auto]
******** Standard Timing Control ********
x CAS Latency Time
4
Auto
x DRAM RAS# to CAS# Delay
4
Auto
x DRAM RAS# Precharge
4
Auto
x Precharge delay (tRAS)
11
Auto
******** Advanced Timing Control ********
x ACT to ACT Delay (tRRD)
2
Auto
x Rank Write To READ Delay
2
Auto
KLJI: Move
Enter: Select
+/-/PU/PD: Value
F10: Save
ESC: Exit
F1: General Help
F5: Previous Values
F6: Fail-Safe Defaults
F7: Optimized Defaults
Item Help
Menu Level`
• Incorrectly doing overclock/overvoltage may result in damage to CPU, chipset, or memory
and reduce the useful life of these components. This page is for advanced users only and
we recommend you not to alter the default settings to prevent system instability or other
unexpected results. (Inadequately altering the settings may result in system's failure to
boot. If this occurs, clear the CMOS values and reset the board to default values.)
we recommend you not to alter the default settings to prevent system instability or other
unexpected results. (Inadequately altering the settings may result in system's failure to
boot. If this occurs, clear the CMOS values and reset the board to default values.)
• When the System Voltage Optimized item blinks in red, it is recommended that you set
the System Voltage Control item to Auto to optimize the system voltage settings.
(Note) This item appears only if you install a CPU that supports this feature.