Insys GPRS 5.0 serial 11-02-01-03-10.014 사용자 설명서
제품 코드
11-02-01-03-10.014
Functions
INSYS GPRS 5.0 serial
52
Mai 06
6.6
Remote Configuration
During a CSD or “TCP transparent” data connection, the INSYS GPRS 5.0
serial can be switched to remote command mode by entering the escape
sequence via the data connection from the remote terminal.
Note: After the 4 escape characters were entered (1 second pause be-
serial can be switched to remote command mode by entering the escape
sequence via the data connection from the remote terminal.
Note: After the 4 escape characters were entered (1 second pause be-
fore and after the entry, no return - <CR> -) at the local device,
the remote configuration at the remote terminal is activated. The
data connection is maintained in the background. The 4 escape
characters must be entered within 1 second.
the remote configuration at the remote terminal is activated. The
data connection is maintained in the background. The 4 escape
characters must be entered within 1 second.
If this was configured, the configuration password is queried before the
switching to the remote command mode occurs.
Note: see also Chap. 6.1.1 – Password protection
After the escape sequence is detected, the prompt for entering the
password appears.
If no valid password is entered within 30 seconds (attention: complete
the entry with line end character), the configuration mode will be exited
with the following message
A valid password is acknowledged with OK; now the AT commands re-
leased for remote configuration can be entered.
Terminate configuration
Note: Due to the sometimes long packet run times for TCP connections,
switching to the remote command mode occurs.
Note: see also Chap. 6.1.1 – Password protection
After the escape sequence is detected, the prompt for entering the
password appears.
If no valid password is entered within 30 seconds (attention: complete
the entry with line end character), the configuration mode will be exited
with the following message
A valid password is acknowledged with OK; now the AT commands re-
leased for remote configuration can be entered.
Terminate configuration
Note: Due to the sometimes long packet run times for TCP connections,
the escape character **** must be sent in one TCP packet. Other-
wise the pauses between the individual characters get too large
and the reception of the sequence is terminated.
wise the pauses between the individual characters get too large
and the reception of the sequence is terminated.
CONFIG PASS-
WORD:
ERROR
ERROR
AT**EXIT
OK
<Pause>
****
<Pause>
****
<Pause>