Insys Modem 56k small INT USB 1.0 11-02-01-01-44.001 사용자 설명서
제품 코드
11-02-01-01-44.001
INSYS Modem 56k small INT 2.0/USB 1.0
FAQ
June 06
85
12 FAQ
In the following some questions are described, which – from experience – may occur dur-
ing the installation.
ing the installation.
Problem:
Possible cause:
Remedy
The modem does not accept
calls.
calls.
Automatic call acceptance is deac-
tivated.
tivated.
Enter the following commands in
the terminal program:
the terminal program:
ATS0=2
AT*A1
The key entries are not dis-
played in the terminal program.
played in the terminal program.
The display of the key entries
(echo) is deactivated.
(echo) is deactivated.
Activate the echo with ATE1.
The modem starts dialing after
the dialing command ATD has
been entered and reports the
error “No Dialtone”.
the dialing command ATD has
been entered and reports the
error “No Dialtone”.
The phone line is interrupted.
Check the phone line.
The modem starts dialing after
the dialing command ATD has
been entered and reports the
error “No Dialtone”.
the dialing command ATD has
been entered and reports the
error “No Dialtone”.
The modem is operated at a PBX.
The PBX requires
The PBX requires
that a code number is dialed to
establish a connection
establish a connection
or that the flash function is acti-
vated, before the dialing tone is
heard. The modem, however, is
awaiting a ring back signal al-
ready before the first digit is di-
aled.
vated, before the dialing tone is
heard. The modem, however, is
awaiting a ring back signal al-
ready before the first digit is di-
aled.
After the leading digit was dialed
without a ring back signal, insert-
ing a W into the dialing string will
re-activate the ring back signal
detection.
without a ring back signal, insert-
ing a W into the dialing string will
re-activate the ring back signal
detection.
(Example ATD0W12345).
This problem can be solved by
blind dialing (dialing without ring
back signal) with the ATX3 com-
mand or by inserting the charac-
ter > into the dialing string. (See
Chapter 9, command ATX,
command ATD)
blind dialing (dialing without ring
back signal) with the ATX3 com-
mand or by inserting the charac-
ter > into the dialing string. (See
Chapter 9, command ATX,
command ATD)
After the ATD dialing com-
mand, the modem will not start
dialing right away.
mand, the modem will not start
dialing right away.
The dialing lock of 3o seconds is
active.
active.
See Chapter 5.2.8 “Dial-up De-
lay”.
lay”.