Jeti 4-channel receiver 2.4 GHz FHSS with Connector system JR 80001221 사용자 설명서
제품 코드
80001221
computer radio control system
EN
5.1 Receiver Setup via the JETIBOX
There are two receiver setup modes. The first is receiver setup via
the JETIBOX, JETIBOX Profi or JETIBOX emulation in the DC/DS
transmitters, the second is one is direct setup of the receiver with a
DC/DS transmitter.
the JETIBOX, JETIBOX Profi or JETIBOX emulation in the DC/DS
transmitters, the second is one is direct setup of the receiver with a
DC/DS transmitter.
5.1.1 Direct connection between a JETIBOX and the
Receiver.
Receiver.
Insert one end of the connection cable (included with the JETIBOX)
into the socket labeled Impuls + - (see the right side of the JETIBOX)
and the other end into the reveiver socket labelled EXT. Connect a
voltage supply to the receiver (see Voltage supply) or to the supply
socket of the JETIBOX. There is no need to supply voltage when
using the JETIBOX Profi.
into the socket labeled Impuls + - (see the right side of the JETIBOX)
and the other end into the reveiver socket labelled EXT. Connect a
voltage supply to the receiver (see Voltage supply) or to the supply
socket of the JETIBOX. There is no need to supply voltage when
using the JETIBOX Profi.
5.1.2 Wireless Connection between a JETIBOX with
Transmitter or DC/DS transmitter and the Receiver.
Transmitter or DC/DS transmitter and the Receiver.
In this case, connect the JETIBOX with the transmitter (if you are
using a DC/DS transmitter, then select the JETIBOX emulation).
Switch-on the Transmitter and then connect the receiver voltage
supply. The Tx heading appears on the display along with right and
down arrows. In order to enter the receiver press the R button
(right), The Rx heading appears on the display and by subsequently
pressing the D button (down) you will enter the receiver menu,
which will be displayed just the same as the direct connection
using a DC/DS transmitter, then select the JETIBOX emulation).
Switch-on the Transmitter and then connect the receiver voltage
supply. The Tx heading appears on the display along with right and
down arrows. In order to enter the receiver press the R button
(right), The Rx heading appears on the display and by subsequently
pressing the D button (down) you will enter the receiver menu,
which will be displayed just the same as the direct connection
5 Receiver setup