AEG AWFLJ4 900 166 654 데이터 시트
제품 코드
900 166 654
MATERIAL SAFETY DATA SHEET Carbon Loaded Web
02/28/11
_________________________________________________________________________________________________
Page 3 of 7
Autoignition temperature
>=250 ºC
Flash Point
>=93 ºC [Test Method: Closed Cup]
Flammable Limits(LEL)
Not Applicable
Flammable Limits(UEL)
Not Applicable
5.2 EXTINGUISHING MEDIA
Use fire extinguishers with class B extinguishing agents (e.g., dry chemical, carbon dioxide).
5.3 PROTECTION OF FIRE FIGHTERS
Special Fire Fighting Procedures: Wear full protective equipment (Bunker Gear) and a self-contained breathing apparatus (SCBA).
Unusual Fire and Explosion Hazards: No unusual fire or explosion hazards are anticipated.
SECTION 6: ACCIDENTAL RELEASE MEASURES
6.1. Personal precautions, protective equipment and emergency procedures
Not applicable.
6.2. Environmental precautions
Not applicable.
Clean-up methods
Not applicable.
SECTION 7: HANDLING AND STORAGE
7.1 HANDLING
Avoid breathing of dust created by cutting, sanding, grinding or machining. This product is considered to be an article which does
not release or otherwise result in exposure to a hazardous chemical under normal use conditions. Avoid eye contact with dust or
airborne particles.
not release or otherwise result in exposure to a hazardous chemical under normal use conditions. Avoid eye contact with dust or
airborne particles.
7.2 STORAGE
Store away from acids. Store away from heat. Store out of direct sunlight. Not applicable.
SECTION 8: EXPOSURE CONTROLS/PERSONAL PROTECTION
8.1 ENGINEERING CONTROLS
Provide local exhaust ventilation at transfer points. Not applicable. Provide appropriate local exhaust for cutting, grinding, sanding
or machining. Provide ventilation adequate to control dust concentrations below recommended exposure limits and/or control dust.
Use general dilution ventilation and/or local exhaust ventilation to control airborne exposures to below Occupational Exposure Limits
and/or control dust, fume, or airborne particles. If ventilation is not adequate, use respiratory protection equipment.
or machining. Provide ventilation adequate to control dust concentrations below recommended exposure limits and/or control dust.
Use general dilution ventilation and/or local exhaust ventilation to control airborne exposures to below Occupational Exposure Limits
and/or control dust, fume, or airborne particles. If ventilation is not adequate, use respiratory protection equipment.
8.2 PERSONAL PROTECTIVE EQUIPMENT (PPE)
8.2.1 Eye/Face Protection
Not applicable.