Texas Instruments TPS61050-215 Evaluation Kit TPS61050EVM-215 TPS61050EVM-215 TPS61050EVM-215 사용자 설명서
제품 코드
TPS61050EVM-215
www.ti.com
3
Software Setup and Operation
Software Setup and Operation
This section provides descriptions of the EVM software.
The supplied software is used to communicate with the TPS61050/2EVM. Click on the icon on the host
PC to start the software. The host PC software first checks the firmware version of the USB-TO-GPIO
adapter box. If an incorrect firmware version is installed, the software automatically searches on the
Internet (if connected) for updates. If a new update is available, the software notifies the user of the
update, downloads and installs the software. Note that after the firmware is updated, the user must
disconnect and then reconnect the USB cable between the adapter and PC, as instructed during the
install process. The host PC software automatically searches on the Internet (if connected) for updates. If
a new update is available, the software notifies the user of the update, downloads and installs the update.
PC to start the software. The host PC software first checks the firmware version of the USB-TO-GPIO
adapter box. If an incorrect firmware version is installed, the software automatically searches on the
Internet (if connected) for updates. If a new update is available, the software notifies the user of the
update, downloads and installs the software. Note that after the firmware is updated, the user must
disconnect and then reconnect the USB cable between the adapter and PC, as instructed during the
install process. The host PC software automatically searches on the Internet (if connected) for updates. If
a new update is available, the software notifies the user of the update, downloads and installs the update.
The software then asks which version of the IC is on the board and the desired current limit. Check the
approriate box for the IC, then select the desired current limit, and finally click the continue button.
Although the PCB can be powered up after the software is initiated, in order for the user to be able to set
the current limit to a value other than the default, the PCB must be powered on before the software is
initiated.
approriate box for the IC, then select the desired current limit, and finally click the continue button.
Although the PCB can be powered up after the software is initiated, in order for the user to be able to set
the current limit to a value other than the default, the PCB must be powered on before the software is
initiated.
The software displays the main control panel for the user interface.
shows the user interface main
control panel.
Figure 1. TPS6105x Software Main Panel
It is recommended that the user press the READ ALL REGISTERS button immediately after loading the
software to confirm that the software and cable connections are working properly. The message box at the
top right of the control panel displays whether or not the TPS61050/2 is operational and the middle
message box at the bottom displays whether or not the USB-TO-GPIO connection s functional.
software to confirm that the software and cable connections are working properly. The message box at the
top right of the control panel displays whether or not the TPS61050/2 is operational and the middle
message box at the bottom displays whether or not the USB-TO-GPIO connection s functional.
6
TPS61050EVM-215 and TPS61052EVM-215
SLVU202B – May 2007 – Revised November 2007