Texas Instruments BQ3060EVM - BQ3060 SBS 1.1 Compliant Advanced Gas Gauge Battery Evaluation Module BQ3060EVM BQ3060EVM 데이터 시트
제품 코드
BQ3060EVM
Circuit Module Physical Layouts and Bill of Materials
www.ti.com
Table 2. Components and Flash-Memory Settings for Different Pre-charge
Modes
MODE
RESISTORS
PRECHG FET
ZVCHG1
ZVCHG0
1. ZVCHG FET
R23
Q4
0
0
2. Not defined
N/A
N/A
0
1
3. Not defined
N/A
N/A
1
0
4. No action
N/A
N/A
1
1
For more details about pre-charge operation and mode choices, see the bq3060 data sheet (
).
3.3
Testing Fuse-Blowing Circuit
To prevent the loss of board functionality during the fuse-blowing test, the actual chemical fuse is not
provided in the circuit. FET Q3 drives TP5 low if a fuse-blow condition occurs (a pull-up at TP5 is
required); so, monitoring TP5 can be used to test this condition.
provided in the circuit. FET Q3 drives TP5 low if a fuse-blow condition occurs (a pull-up at TP5 is
required); so, monitoring TP5 can be used to test this condition.
4
Circuit Module Physical Layouts and Bill of Materials
This section contains the board layout, bill of materials, and assembly drawings for the bq3060/bq29412
circuit module.
circuit module.
NOTE:
The optional zener diode (D4) and resistor (R32) on the SYS PRES pin, which are only
required if SYS PRES has a chance to short to PACK+, are not available on REV. A EVM.
4.1
Board Layout
This section shows the dimensions, PCB layers (
through
), and assembly drawing for the
bq3060 module.
Figure 1. bq3060EVM-001 Layout (Silk Screen)
4
bq3060EVM-001 SBS 1.1 Compliant Advanced Gas Gauge Battery
SLUU342 – October 2009
Management Solution EVM
Copyright © 2009, Texas Instruments Incorporated