Texas Instruments Evaluation Module for TPS22913B TPS22913BEVM-656 TPS22913BEVM-656 데이터 시트
제품 코드
TPS22913BEVM-656
Operation
3
Operation
Connect the positive input of the power supply to the VIN J1 and the negative lead of the power supply to
GND J3. The input voltage range of the TPS2291xx is 1.4 V to 5.5 V.
GND J3. The input voltage range of the TPS2291xx is 1.4 V to 5.5 V.
Output load can be applied by connecting between J4 VOUT and J6 GND. The TPS2291xx is rated for a
maximum continuous current of 2A. Configure jumper JP3 as required. JP3 must be installed for proper
operation. When the ON pin is asserted, the TPS2291xx will control the slew rate of VOUT. The slew rate
of the device is internally controlled to avoid inrush current. When ON is deasserted, the TPS2291xx will
open the P-Channel MOSFET. Devices equipped with the Quick Output Discharge (QOD) option will
connect a 150
maximum continuous current of 2A. Configure jumper JP3 as required. JP3 must be installed for proper
operation. When the ON pin is asserted, the TPS2291xx will control the slew rate of VOUT. The slew rate
of the device is internally controlled to avoid inrush current. When ON is deasserted, the TPS2291xx will
open the P-Channel MOSFET. Devices equipped with the Quick Output Discharge (QOD) option will
connect a 150
Ω
on-chip load resistor to the output for quick discharge. Devices equipped with the QOD
function are noted in
4
Test Results
See the Typical Characteristics section of the TPS2291xx data sheet.
3
SLVU501A
–
August 2011
–
Revised January 2012
TPS2291xxEVM-656
Copyright
©
2011
–
2012, Texas Instruments Incorporated