Texas Instruments Evaluation Module for UCC28250 Advanced PWM Controller with Pre-Bias Operation UCC28250EVM-501 UCC28250EVM-501 데이터 시트

제품 코드
UCC28250EVM-501
다운로드
페이지 19
User's Guide
SLUU429B – June 2010 – Revised December 2010
Half-Bridge DC-to-DC Converter With Primary-Side Control
1
Introduction
This EVM is to help evaluating UCC28250 PWM device with primary-side control in DC-to-DC symmetrical
half-bridge converter topology. The targeted application is telecom module design with nominal 48-V input.
UCC28250 is a PWM controller that can be used for primary-side control or secondary-side control. In this
EVM, the UCC28250 is placed at primary side to make primary-side control.
2
Description
The EVM is a 75-W symmetrical half-bridge DC-to-DC converter that converts 36-V to 72-V DC to a
regulated output voltage 3.3 V and maximum 23-A load current.
2.1
Typical Applications
Telecom power supplies with primary-side control
Server systems
Datacom
DSP’s, ASIC’s, and FPGA’s
2.2
Features
Start up directly from telecom telecom input voltage 36-V to 72-V DC.
Regulated output voltage 3.3 V with maximum 23-A load current.
Telecom basic isolation from primary to secondary 1500 V.
Output voltage regulation from no load to full load, and from low line to high line.
Control driven synchronous rectifier.
All surface mount components, double sided close to form factor of quarter brick.
Voltage mode control.
Remote Enable ON/OFF Function and manual switch.
Non-latching input over voltage protection.
Non-latching input under voltage protection.
Hiccup over current protection.
Test points to facilitate the devices evaluation.
2
Half-Bridge DC-to-DC Converter With Primary-Side Control
SLUU429B – June 2010 – Revised December 2010
© 2010, Texas Instruments Incorporated