Texas Instruments Evaluation Board for the LP38511 LP38511TJ-ADJEV LP38511TJ-ADJEV 데이터 시트
제품 코드
LP38511TJ-ADJEV
Enable Function
6
Enable Function
ON/OFF control is provided by supplying a logic level signal to the Enable pin. A minimum V
EN
value of 1.2
V is typically required at this pin to enable the LDO output. The LDO output is shutdown when the V
EN
value is typically 0.6 V or less. The V
EN
threshold incorporates approximately 100 mV of hysteresis.
Figure 3. V
OUT
vs V
EN
The Enable pin has no internal default bias and must not be left floating. The Enable pin must be actively
driven to the appropriate voltage level. In applications where the LP38513TJ is operated continuously, the
Enable pin can be connected directly to V
driven to the appropriate voltage level. In applications where the LP38513TJ is operated continuously, the
Enable pin can be connected directly to V
IN
. The LP38511TJ-ADJ evaluation board is assembled with a 10
k
Ω
resistor (R3) to provide pull-up to V
IN
.
Figure 4. Enable Thresholds
7
Power Dissipation
The TO-263 THIN package alone has a junction to ambient thermal resistance (
θ
JA
) rating of 67°C/W.
When mounted on the LP38511TJ-ADJ evaluation board, the
θ
JA
rating is approximately 35°C/W.
Although there is only approximately 0.20 square inches (0.45in x 0.45in) of 1 ounce copper area
immediately under the package body, the top copper surface area is extended to additional copper area
on the bottom of the board by fifteen thermal vias.
immediately under the package body, the top copper surface area is extended to additional copper area
on the bottom of the board by fifteen thermal vias.
4
AN-1801 LP38511TJ-ADJ Evaluation Board
SNVA330B – January 2009 – Revised April 2013
Copyright © 2009–2013, Texas Instruments Incorporated