Texas Instruments DRV8313 Evaluation Module DRV8313EVM DRV8313EVM 데이터 시트
제품 코드
DRV8313EVM
RUNNING THE HARDWARE IN STAND-ALONE MODE
7
RUNNING THE HARDWARE IN STAND-ALONE MODE
The firmware loaded by default in the MCU on board is a User Experience code. Using this firmware will
need the GUI to run the motor.
need the GUI to run the motor.
However, once motor parameters are tuned, the output of the GUI can be used to operate the hardware in
a stand-alone mode (without GUI). These parameters are given by the GUI in form of the ‘config.c’ file
which is further used to change the code inside the MCU on hardware.
a stand-alone mode (without GUI). These parameters are given by the GUI in form of the ‘config.c’ file
which is further used to change the code inside the MCU on hardware.
Figure 12. Config Tab
Once the parameters are tuned, clicking on ‘Generate Config File’ will generate a config.c file which will be
used for the creating new firmware for the MSP430 device on the hardware. This new code can be
flashed via MSP430 Programming Connector using Spy-Bi Wire programming method as explained in
Appendix B.
used for the creating new firmware for the MSP430 device on the hardware. This new code can be
flashed via MSP430 Programming Connector using Spy-Bi Wire programming method as explained in
Appendix B.
User Experience code can be downloaded from
. Importing
"DRV8313_Release" project in CCS will get us the following view.
14
DRV8313EVM User’s Guide
SLVU815 – November 2012
Copyright © 2012, Texas Instruments Incorporated