Texas Instruments Evaluation Module for TPS6236 TPS62362EVM-655 TPS62362EVM-655 데이터 시트
제품 코드
TPS62362EVM-655
Host
Computer
USB Cable
USB
Interface
Adapter
Green LED
Indicates
Power
10-Pin
Ribbon
Cable
EVM Board
USB Interface Adaptor Quick Connection Diagram
Setup
2.3
Hardware Setup
shows the board default jumper settings.
Table 2. Default Jumper Settings
JUMPER
DEFAULT
JP1
Installed across pins 1 and 2
JP2
Installed across pins 2 and 3
JP3
Installed across pins 2 and 3
JP4
Installed across pins 1 and 2
Connect the USB-TO-GPIO adapter to your PC using the supplied USB cable. Connect the
TPS6236xEVM connector J8 to the USB-TO-GPIO adapter using the supplied 10-pin ribbon cable. The
connectors on the ribbon cable are keyed to prevent incorrect installation.
TPS6236xEVM connector J8 to the USB-TO-GPIO adapter using the supplied 10-pin ribbon cable. The
connectors on the ribbon cable are keyed to prevent incorrect installation.
Connect the load (processor) to either the output headers J4 and J6 (for currents below 1A) or to the
output terminal block J7 (for currents greater than 1A). The leads should be short and twisted.
output terminal block J7 (for currents greater than 1A). The leads should be short and twisted.
Connect the SNS+ and SNS- signals from header J5 to the load. For proper regulation, these must be
connected to the output.
connected to the output.
Install jumpers, JP1 through JP4 to the desired positions. Jumper JP1 must be across pins 1 and 2 for the
TPS6236x to operate.
TPS6236x to operate.
Connect at least a 3 A rated input power supply, set to provide between 2.5V and 5.5V, between J1 and
J3. The leads should be short and twisted. Turn on the power supply.
J3. The leads should be short and twisted. Turn on the power supply.
5
SLVU425A
–
April 2011
–
Revised July 2011
TPS6236xEVM-655
Copyright
©
2011, Texas Instruments Incorporated