Texas Instruments Evaluation Module for TPS65253 TPS65253EVM TPS65253EVM 데이터 시트
제품 코드
TPS65253EVM
Bench Test Setup Conditions
5.2
Jumpers
Table 2. Jumpers
JUMPER
FUNCTION
PLACEMENT
COMMENT
NO.
For sequencing do not fit jumper.
JP6
BUCK1 enable (EN1)
Fit according to test requirement
To disable converter fit jumper to GND.
For sequencing do not fit jumper.
JP15
BUCK2 enable (EN2)
Fit according to test requirement
To disable converter fit jumper to GND.
Low power: Power save mode ON/OFF.
Fit according to test requirement.
JP20
LOW_P
If need low power mode test, should connect
During normal operation jumper must
V3V.
be fitted.
Pulls PGOOD signal to internal 3V3 rail or
JP24
PGOOD
Fit according to test requirement
grounds pin
5.3
Test Points and Placement
Buck converter outputs are white and have a label for easy location. Close to any of these test points
there are black ground test points to allow for DVM measurement or to use a metal exposed scope probe
to reduce common mode noise measurements. All test points are described in
there are black ground test points to allow for DVM measurement or to use a metal exposed scope probe
to reduce common mode noise measurements. All test points are described in
.
Table 3. Test Points and Placement
TEST
NAME
SIGNAL
COLOR
COMMENT
POINT
TP1, TPS, TP3,
GND
Ground
Black
TP4, TP5
TP8
VIN
Input supply
White
TP9, TP9A
VOUT1
Buck1 output
White
TP9B
Input for gain-phase measurement Buck1
White
Normally not used
TP11, TP11A
VOUT2
Buck2 output
White
TP11B
Input for gain-phase measurement Buck2
White
Normally not used
TP20
Low_P
Low Power input
White
Power Good
TP24
PGOOD
White
(open drain connected to Buck1 output)
11
SLVU469
–
June 2011
List of Tables
Copyright
©
2011, Texas Instruments Incorporated