Texas Instruments C2000 Digital Power Experimenter Kit TMDSDCDC2KIT TMDSDCDC2KIT 데이터 시트

제품 코드
TMDSDCDC2KIT
다운로드
페이지 7
2
Getting Started
2.1
Hardware Components
Main Pwr
(SW1)
Load 2
Load 1
9 V In
DC Bus
(SW2)
Emulator
Power
Jumper
Boot Jumpers
Buck 2
Buck 1
Comms
Active Load
DMM
V1/V2
Select
(SW3)
www.ti.com
Getting Started
The Digital Power Experimenter Kit consists of two identical buck power stages. The input bus voltage for
both stages is 9 V.
is a diagram of the Digital Power Experimenter board and some key features.
Figure 1. Hardware Components
Table 1. Hardware Components
Component
Description
9 V In
DC power supply from plug pack (12-V supply may be used as well)
Main Pwr
SW1 - Master power switch for entire EVM
DC Bus
SW2 - Power switch for Vin to buck stages only. When off the DIMM controller card will still operate (next to the
DC bus switch is a resettable fuse)
Buck 1, 2
Buck power stage modules with temperature/current measurement and over current protection
Load 1
Buck converter output for Channel 1 is tied to two 2
Ω
resistors in parallel. If desired, load 1 can be desoldered
and a terminal block as in Channel 2 can be reinstalled.
Load 2
Load terminals and/or buck converter output - next to each terminal block is a light bulb or “visual” load (these
draw approx 250 mA hot)
Active Load
Software controlled switched load (connected to output of buck 1 only)
DMM
Digital Multi-Meter has a range of 0~20 V, with resolution of 10 mV and is used to measure output voltage of buck
converters)
V1/V2 Select
SW3 - selects the display of the DMM between output voltage of buck 1 and 2
Comms
Serial communications UART (connects to an optional GUI, not used in lab exercises)
Emulator
Sets the voltage sent to power the emulator. No jumper means no power will be sent to an emulator, a jumper at
Power Jumper
5V powers the emulator with 5 V, and a jumper at 3V3 will power the emulator with 3.3 V.
Boot Jumpers
Controls how the F280x will boot.
If no jumpers are placed, the target boots from flash.
If a jumper is placed at 34, the target boots from the SCI
If a jumper is placed at 29 and 34, the target boots from RAM
SPRUFR6 – June 2008
Digital Power Experimenter Kit
3