Texas Instruments THS3201 Evaluation Module THS3201EVM THS3201EVM 데이터 시트
제품 코드
THS3201EVM
www.ti.com
.............................................................................................................................................................
SLOS416C – JUNE 2003 – REVISED JUNE 2009
EVM WARNINGS AND RESTRICTIONS
It is important to operate this EVM within the input voltage and the output voltage ranges as specified in the table below.
Input Range, V
S
6.6 V (±3.3V) to 16.5V (±8.25V)
Input Range, V
I
NOT TO EXCEED: Power-Supply Voltage Applied
Output Range, V
O
NOT TO EXCEED: Power-Supply Voltage Applied
Exceeding the specified input range may cause unexpected operation and/or irreversible damage to the EVM. If there are questions
concerning the input range, please contact a TI field representative prior to connecting the input power.
concerning the input range, please contact a TI field representative prior to connecting the input power.
Applying loads outside of the specified output range may result in unintended operation and/or possible permanent damage to the EVM.
Please consult the EVM User's Guide prior to connecting any load to the EVM output. If there is uncertainty as to the load specification,
please contact a TI field representative.
Please consult the EVM User's Guide prior to connecting any load to the EVM output. If there is uncertainty as to the load specification,
please contact a TI field representative.
During normal operation, some circuit components may have case temperatures greater than +125°C. The EVM is designed to operate
properly with certain components above +125°C as long as the input and output ranges are maintained. These components include but are
not limited to linear regulators, switching transistors, pass transistors, and current sense resistors. These types of devices can be identified
using the EVM schematic located in the EVM User's Guide. When placing measurement probes near these devices during operation,
please be aware that these devices may be very warm to the touch.
properly with certain components above +125°C as long as the input and output ranges are maintained. These components include but are
not limited to linear regulators, switching transistors, pass transistors, and current sense resistors. These types of devices can be identified
using the EVM schematic located in the EVM User's Guide. When placing measurement probes near these devices during operation,
please be aware that these devices may be very warm to the touch.
Mailing Address: Texas Instruments, Post Office Box 655303, Dallas, Texas 75265
Copyright 2008, Texas Instruments Incorporated
Copyright © 2003–2009, Texas Instruments Incorporated
25
Product Folder Link(s):