Texas Instruments TPS62750EVM-413 Evaluation Module TPS62750EVM-413 TPS62750EVM-413 데이터 시트
제품 코드
TPS62750EVM-413
2.4
JP1 – EN (ENABLE)
2.5
JP2 – Current Select
3
Operation
4
Test Results
ENABLE
V-OUT
INPUT CURRENT
5 V/div
1 V/div
200 mA/div
Operation
www.ti.com
This jumper enables or disables the converter. Connecting the shorting jumper between EN and ON
enables the converter. Connecting the shorting jumper between EN and OFF disables the converter. Do
not leave this pin floating.
enables the converter. Connecting the shorting jumper between EN and OFF disables the converter. Do
not leave this pin floating.
This jumper sets the input current selection from high to low. Resistor R3 sets low-input current and
resistor R4 sets high-input current. The EVM is set for 100 mA in low position and 500 mA in high
position. Do not leave this pin floating.
resistor R4 sets high-input current. The EVM is set for 100 mA in low position and 500 mA in high
position. Do not leave this pin floating.
Connect the positive input power supply to the pins J1, and connect the input power return (ground) to the
GND pins on J3. The TPS62750EVM-413 has a maximum input voltage and operating voltage of 6 V.
GND pins on J3. The TPS62750EVM-413 has a maximum input voltage and operating voltage of 6 V.
Connect the desired load between the Vogt pin, J4 and GND pins J6. The TPS62750 EVM is set for 3.6 V
out and maximum current can be up to 2 A at high-input voltage.
out and maximum current can be up to 2 A at high-input voltage.
Configure jumpers JP1 to turn the device On or Off. Configure jumper JP4 to select high- or low-input
current.
current.
This section provides typical performance waveforms using the TPS62750EVM-413 PCB.
Figure 1. Turnon With Enable and Current Limit Set to Low, Time Base 10 ms
2
TPS62750EVM-413
SLVU322 – August 2008