Texas Instruments YPbPr to RGBHV Converter and 2:1 Video Switch LMH1251EVAL/NOPB LMH1251EVAL/NOPB 데이터 시트
제품 코드
LMH1251EVAL/NOPB
Board Electrical Specifications
2
Board Electrical Specifications
Power Requirements:
V
CC
= +6.0 ±0.1 V, (at least 300 mA)
Analog Video Input:
0.7 V
PP
RGB or YP
B
P
R
(1.0 V
PP
including sync.)
•
PROGRESSIVE SCAN DVD Players
•
480i, 480p, 576i, 576p, 720p, 1080i, 1080p/60 video sources
•
VGA - UXGA VESA video sources
3
Jumper Instructions
JP1:— SD/HD Selection. (This should be left un-jumpered, when in Auto Mode, which is typically
recommended.)
JP2:— Input Source Select
JP3:— Auto/Manual Mode Select
JP4:— Power Save Mode
JP5:— Horizontal Sync Output Polarity
JP6:— Vertical Sync Output Polarity
•
Power save mode is enabled when “HIGH” and disabled when “LOW”
•
Auto mode is selected when JP3 is “HIGH”, and manual mode is selected when JP3 is “LOW”
•
Input source 1 (PC/VGA) is selected when JP2 is “LOW”, and input source 2 (YP
B
P
R
) is selected when
JP2 is “HIGH”
•
IF manual mode is selected, SD (480p) corresponds to JP1 being “LOW” and HD (720p and 1080i)
corresponds to being “HIGH.” IF auto mode is selected, JP1 must be left un-jumpered, and TP14 will
measure “LOW” or “HIGH” depending on whether the input is SD or HD, respectively.
corresponds to being “HIGH.” IF auto mode is selected, JP1 must be left un-jumpered, and TP14 will
measure “LOW” or “HIGH” depending on whether the input is SD or HD, respectively.
2
AN-1836 LMH1251 Evaluation Board v2.0
SNOA526A – June 2008 – Revised April 2013
Copyright © 2008–2013, Texas Instruments Incorporated