Texas Instruments Multi-Cal-System Basic Starter Kit MULTI-CAL-SYSTEM MULTI-CAL-SYSTEM 데이터 시트
제품 코드
MULTI-CAL-SYSTEM
USB DAQ
Platform
EVM
Power
Multi-Cal-Master
Multi-Cal-Interface Board
Pressure Sensors in Pressure Manifold
Pressure
Source
±15V
Loop or
DUT
Power
DMM
RS-232 or
IEEE488
Starter System Setup
2
Starter System Setup
shows the system setup for the Multi-Cal-System EVM. The PC runs software that communicates
with the USB-DAQ-Platform. The USB-DAQ-Platform generates the digital signals used to communicate
with the Multi-Cal-System EVM.
with the Multi-Cal-System EVM.
Figure 7. Multi-Cal-System EVM Hardware Setup
2.1
Electrostatic Discharge Warning
Many of the components on the Multi-Cal-System EVM are susceptible to damage by electrostatic
discharge (ESD). Customers are advised to observe proper ESD handling precautions when unpacking
and handling the EVM, including the use of a grounded wrist strap at an approved ESD workstation.
discharge (ESD). Customers are advised to observe proper ESD handling precautions when unpacking
and handling the EVM, including the use of a grounded wrist strap at an approved ESD workstation.
CAUTION
Failure to observe ESD handling procedures may result in damage to EVM
components.
components.
9
SBOU087A
–
August 2010
–
Revised April 2011
Multi-Cal-System Evaluation Module
Copyright
©
2010
–
2011, Texas Instruments Incorporated