Texas Instruments BUF22821 Evaluation board BUF22821EVM-USB BUF22821EVM-USB 데이터 시트
제품 코드
BUF22821EVM-USB
BUF22821EVM-USB Hardware
3.5
Connecting the USB Cable to the USB_DIG_Platform
Once power is connected, the USB cable must be connected to the DIG, as shown in
.
Figure 7. Connecting the USB Cable to the USB_DIG_Platform
Note that the Test Board and USB_DIG_Platform must be powered on before connecting the USB cable.
Typically, the computer responds with a Found New Hardware, USB Device pop-up dialog. The popup
window typically changes to Found New Hardware, USB Human Interface Device. This pop-up window
indicates that the device is ready to be used. The USB_DIG_Platform uses the human interface device
drivers that are part of the Microsoft
Typically, the computer responds with a Found New Hardware, USB Device pop-up dialog. The popup
window typically changes to Found New Hardware, USB Human Interface Device. This pop-up window
indicates that the device is ready to be used. The USB_DIG_Platform uses the human interface device
drivers that are part of the Microsoft
®
Windows
®
operating system.
In some cases, the Windows Add Hardware wizard is shown. If this prompt appears, allow the system
device manager to install the human interface drivers by clicking Yes when requested to install drivers.
Windows then confirms installation of the drivers with the message shown in
device manager to install the human interface drivers by clicking Yes when requested to install drivers.
Windows then confirms installation of the drivers with the message shown in
.
Figure 8. Confirmation of USB_DIG_Platform Driver Installation
9
SBOU117
–
September 2011
BUF22821EVM-USB Evaluation Board and Software Tutorial
Copyright
©
2011, Texas Instruments Incorporated