Texas Instruments BUF18830 Evaluation Module BUF18830EVM BUF18830EVM 데이터 시트
제품 코드
BUF18830EVM
BUF18830EVM Hardware Overview
www.ti.com
3.5
Connecting the USB Cable to the BUF18830EVM
Once power is connected, the USB cable must be connected to the USB_DIG_Platform, as shown in
. Note that the BUF18830EVM test board and the USB_DIG_Platform board must each be
powered on before connecting the USB cable. Typically, the computer will respond with a Found New
Hardware, USB Device pop-up dialog. The pop-up window typically changes to Found New Hardware,
USB Human Interface Device. This pop-up indicates that the device is ready to be used. The
USB_DIG_Platform uses the human interface device drivers that are part of the Microsoft
Hardware, USB Device pop-up dialog. The pop-up window typically changes to Found New Hardware,
USB Human Interface Device. This pop-up indicates that the device is ready to be used. The
USB_DIG_Platform uses the human interface device drivers that are part of the Microsoft
®
Windows
®
operating system.
Figure 7. Connecting the USB Cable to the USB_DIG_Platform
In some cases, the Windows Add Hardware Wizard may pop up. If this prompt appears, allow the system
device manager to install the human interface drivers by clicking Yes when requested to install drivers.
Windows will confirm installation of the drivers with the message shown in
device manager to install the human interface drivers by clicking Yes when requested to install drivers.
Windows will confirm installation of the drivers with the message shown in
.
Figure 8. Confirmation of USB_DIG_Platform Driver Installation
10
BUF18830EVM User Guide and Software Tutorial
SBOU103 – April 2011
© 2011, Texas Instruments Incorporated