Texas Instruments LDC1000EVM - Evaluation Module for Inductance to Digital Converter with Sample PCB Coil LDC1000EVM LDC1000EVM 사용자 설명서
제품 코드
LDC1000EVM
Chapter 2
SNAU150 – September 2013
Quick Start Guide LDC1000 Evaluation Module
2.1
LDC1000 Evaluation Module Overview
The LDC1000 Evaluation Module (EVM) enables the user to test out analog and digital capabilities of the
LDC1000 Inductance-to-Digital Converter. The EVM is a USB device used with a host computer and
accessed using the Inductive Sensing Graphical User Interface (GUI) software, which is documented in
LDC1000 Inductance-to-Digital Converter. The EVM is a USB device used with a host computer and
accessed using the Inductive Sensing Graphical User Interface (GUI) software, which is documented in
.
To quickly get started on the LDC1000 GUI, follow the steps below to load and configure a device.
2.1.1 Evaluation Module
Set Up Requirements
1. The LDC1000 GUI and drivers must be installed on the host.
2. The USB port of the EVM must be connected to the host.
Loading and Running
1. Plug the EVM into the host computer. The host computer should automatically detect the device as
LDC1000EVM.
2. Launch the GUI. It should automatically detect the target, read all the configuration registers, and begin
streaming data.
Figure 2-1. Streaming Section
3
SNAU150 – September 2013
Quick Start Guide LDC1000 Evaluation Module
Copyright © 2013, Texas Instruments Incorporated