Texas Instruments BUF08832 Evaluation Module BUF08832EVM BUF08832EVM 데이터 시트
제품 코드
BUF08832EVM
www.ti.com
BUF08832EVM Hardware Overview
3.6
BUF08832EVM Default Jumper Settings
shows the default jumpers configuration for the BUF08832EVM. In general, the jumper settings of
the USB DIG Platform will not need to be changed. You may want to change some of the jumpers on the
BUF08832_Test_Board to match your specific configuration. For instance, you may wish to set a specific
I
BUF08832_Test_Board to match your specific configuration. For instance, you may wish to set a specific
I
2
C address on the DUT.
Figure 8. BUF08832EVM Default Jumper Settings
Jumpers 2 through 5 on the BUF08832_Test_Board are all typically set to the same position. When set to
the INT position, the signals for digital supply, bank select and the digital communication lines are
generated and controlled from the USB_DIG_Platform or by the onboard bank select switch. When these
jumpers are set to the EXT position, the previously described signals connect to the terminal strips T1, T2,
and T3. Jumper 1 controls the I
the INT position, the signals for digital supply, bank select and the digital communication lines are
generated and controlled from the USB_DIG_Platform or by the onboard bank select switch. When these
jumpers are set to the EXT position, the previously described signals connect to the terminal strips T1, T2,
and T3. Jumper 1 controls the I
2
C address pin for the BUF08832. This jumper can set the address for A0
to either high or low.
11
SBOU081 – November 2009
BUF08832EVM User Guide and Software Tutorial
Copyright © 2009, Texas Instruments Incorporated