Texas Instruments BQ51013AEVM-765 Integrated Wireless Power Receiver Solution, Qi Evaluation Module (QFN Package) BQ5101 BQ51013AEVM-765 데이터 시트
제품 코드
BQ51013AEVM-765
Connector and Test Point Descriptions
4.3.2
TP2 – AC Input 2
This is the test point for measuring ac voltage applied to the EVM from the receiver coil.
4.3.3
TP3 – Com2 Communication 2 Drive
Communication driver signal, open-drain output connected to communication capacitor.
4.3.4
TP4 – AC Input 1
This is the test point for measuring ac voltage applied to the EVM from the receiver coil.
4.3.5
TP5 – CLMP 1
Overvoltage clamp driver signal, open-drain output is connected to OVP capacitor.
4.3.6
TP6 – CLMP 2
Overvoltage clamp drive signal, open-drain output is connected to OVP capacitor.
4.3.7
TP7 – OUT Output Voltage
This test point is the output voltage from the bq51013 or the Adapter input.
4.3.8
TP8 – Boot-1 Boot Capacitor
This bootstrap capacitor 1 drive connects to the integrated circuit (IC).
4.3.9
TP9 – Boot-2 Boot Capacitor
This bootstrap capacitor 2 drive connects to the IC.
4.3.10
TP10 – CHG Charge
This output signal indicates that the output current is being delivered to OUT, the open-drain output.
4.3.11
TP11 – AC1 IC input
This is the ac input to the IC from series capacitors.
4.3.12
TP12 – Rectified Voltage
The input ac voltage is rectified into unregulated dc voltage; additional capacitance is used to filter the
voltage before the regulator.
voltage before the regulator.
4.3.13
TP13, TP14, TP15 – GND
These are the ground test points.
4.3.14
TP16 – TS Temp Sensor
This is the connection point for external thermistor; see the data sheet for additional information.
4.3.15
TP17 – FOD
Input for rectified power measurment, pin 14 of the IC.
4.3.16
TP18– ILIM
Programming pin for over current limit, pin 12 of the IC.
4
bq51013AEVM-765 Evaluation Module (QFN Package)
SLUU911A – June 2012 – Revised October 2012
Copyright © 2012, Texas Instruments Incorporated