Texas Instruments DAC5681ZEVM - DAC5681Z Evaluation Module DAC5681ZEVM DAC5681ZEVM 데이터 시트
제품 코드
DAC5681ZEVM
4.7.2
RF Output
DAC5681/81Z/82z EVM Hardware Description
www.ti.com
2. R109, R134, R135 and R136 need to be installed
Figure 6. DAC5682Z DAC Output Resistor Configuration
If the board is configured for DAC outputs, the TRF3703 modulator is not used and the 5-Vdc supply is
unnecessary. The DAC outputs in this setup are in J1 and J3.
unnecessary. The DAC outputs in this setup are in J1 and J3.
To configure the DAC5682z EVM to evaluate the RF output (default setup), the following changes need to
be done to the board:
be done to the board:
1. R137, R153, R155 and R156 need to be installed
2. R109, R134, R135 and R136 need to be uninstalled
2. R109, R134, R135 and R136 need to be uninstalled
Figure 7. DAC5682z RF Output Resistor Configuration
If the board is configured for RF output, the 5-Vdc must be applied to power up the modulator. The output
in this setup is in J16.
in this setup is in J16.
10
DAC5681/81z/82z EVM
SLAU236A – November 2007 – Revised October 2008