Texas Instruments ISO154XEVM - ISO154xEVM Evaluation Module ISO154XEVM ISO154XEVM 데이터 시트
제품 코드
ISO154XEVM
Introduction
1
Introduction
This User’s Guide details the ISO154x Evaluation Module (EVM) operation of the factory-installed
ISO1540 and ISO1541 I
ISO1540 and ISO1541 I
2
C-compatible bidirectional isolators. The EVM may be reconfigured for use with
two ISO1540 or two ISO1541 instead of one of each.
This Guide presents a typical laboratory setup used with this EVM.
CAUTION
This Evaluation Module (EVM) is made available for isolator parameter
performance evaluation only and is not intended for isolation voltage testing. To
prevent damage to the EVM, any voltage applied as a supply or digital
input/output must be maintained within the 0 V to 5.5 V recommended
operating range.
performance evaluation only and is not intended for isolation voltage testing. To
prevent damage to the EVM, any voltage applied as a supply or digital
input/output must be maintained within the 0 V to 5.5 V recommended
operating range.
Exceeding the specified input voltage range may cause unexpected operation and irreversible damage to
the EVM. If there are questions concerning the input voltage range, contact a TI field representative prior
to connecting power.
the EVM. If there are questions concerning the input voltage range, contact a TI field representative prior
to connecting power.
Applying loads outside the specified output range may result in unintended operation and possible
permanent damage to the EVM. If there is uncertainty as to the load specification, contact a TI field
representative.
permanent damage to the EVM. If there is uncertainty as to the load specification, contact a TI field
representative.
1.1
Overview
The ISO154x devices are low-power, bidirectional isolators that are compatible with I
2
C interfaces. The
logic input and output buffers on these devices are separated by TI’s Capacitive Isolation technology
utilizing a silicon dioxide (SiO
utilizing a silicon dioxide (SiO
2
) barrier. When used in conjunction with isolated power supplies, these
devices block high voltages, isolate grounds and prevent noise currents from entering the local ground
and interfering with or damaging sensitive circuitry.
and interfering with or damaging sensitive circuitry.
The ISO1540 has two isolated bidirectional channels for clock and data lines and is fit for multi-master
applications. The ISO1541 has a bidirectional data and a unidirectional clock channel and is useful in
applications that have a single master.
applications. The ISO1541 has a bidirectional data and a unidirectional clock channel and is useful in
applications that have a single master.
These devices achieve isolated bidirectional communication by introducing an offset, making the side 1
low-level output greater than the side 1 low-level input and thus preventing an internal logic latch that
otherwise would occur with standard digital isolators.
low-level output greater than the side 1 low-level input and thus preventing an internal logic latch that
otherwise would occur with standard digital isolators.
1.2
ISO154xEVM Kit Contents
1. ISO154xEVM Circuit Board (PWB P/N 6547206)
2. ISO154xEVM User’s Guide (
- this document)
3. ISO154x Datasheet (
2
SLLU166 – June 2012
ISO154xEVM Low-Power Bidirectional I
2
C Isolators Evaluation Module
Copyright © 2012, Texas Instruments Incorporated