Texas Instruments TPS2413 Evaluation Module TPS2413EVM TPS2413EVM 데이터 시트
제품 코드
TPS2413EVM
www.ti.com
Channel 1
TPS2412
Channel 2
TPS2412
Glitch
Maker
Output
FET
Output
FET
Load
PS2
PS1
+5V PS
3
Materials Needed
Materials Needed
Reference
, a block diagram of the HPA227.
•
The 5-V supply is jumper selected to power V
DD
on the TPS2412s and the glitch circuit if the control
voltage is less than 3.0 V.
•
The Glitch maker, discussed in the Test Methods section applies a 1-
Ω
load to the input supply for 1
ms. This disruption allows the user to scope test points and observe system recovery.
•
The R
SET
resistor is used to program the turn off point of the TPS2411.
Figure 2. EVM Block Diagram
TI Supplied:
•
TPS2412 evaluation module
•
TPS2412 reference design documentation
•
TPS2412 datasheet
User Supplied:
•
Two power supplies for wire–OR to load, up to 15 A
•
1-V to 5-V power supply for V
DD
•
Power supply cables
•
Load-active load, power resistors or actual load
•
Oscilloscope
•
Current probe
•
Differential probe
4
TPS2412/13 Evaluation Module, HPA227
sluu267 – January 2007