Texas Instruments BQ24159EVM-697 Evaluation Module BQ24159EVM-697 BQ24159EVM-697 데이터 시트
제품 코드
BQ24159EVM-697
Test Summary
1.5
Recommended Operating Conditions
Min
Typ
Max
Unit
Supply voltage, V
IN
Input voltage from ac adapter input
4
5
6
V
Battery voltage, V
BAT
Voltage applied at VBAT terminal of J8
0
3-4.2
4.44
V
Supply current, I
AC
Maximum input current from ac adapter input
0.1
0.1–0.5
1.5
A
Charge current, I
chrg
Battery charge current
0.325
0.7
1.55
A
Operating junction temperature range, T
J
0
125
°C
2
Test Summary
This procedure details how to configure the HPA697 evaluation board for bench evaluation. An electronic
load is used to simulate a battery.
load is used to simulate a battery.
2.1
Definitions
This procedure details how to configure the HPA697 evaluation board. The following naming conventions
are followed. See the bq24153A/56A/57/58/59EVM (also know as HPA697) schematic for details.
are followed. See the bq24153A/56A/57/58/59EVM (also know as HPA697) schematic for details.
VXXX :
External voltage supply name (VADP, VBT, VSBT)
LOADW:
External load name (LOADR, LOADI)
V(TPyyy):
Voltage at internal test point TPyyy. For example, V(TP12) means the voltage at
TP12.
TP12.
V(Jxx):
Voltage at jack terminal Jxx
V(TP(XXX)):
Voltage at test point XXX. For example, V(ACDET) means the voltage at the test
point which is marked as ACDET.
point which is marked as ACDET.
V(XXX, YYY):
Voltage across point XXX and YYY.
I(JXX(YYY)):
Current going out from the YYY terminal of jack XX.
Jxx(BBB):
Terminal or pin BBB of jack xx
Jxx ON :
Internal jumper Jxx terminals are shorted
Jxx OFF:
Internal jumper Jxx terminals are open
Jxx (-YY-)
ON: Internal jumper Jxx adjacent terminals marked as YY are shorted
Measure:
→
A,B
Check specified parameters A, B. If measured values are not within specified limits
the unit under test has failed.
the unit under test has failed.
Observe
→
A,B
Observe if A, B occur. If they do not occur, the unit under test has failed.
Assembly drawings have location for jumpers, test points, and individual components.
2.2
Recommended Test Equipment
2.2.1
Power Supplies
Power Supply #1 (PS#1): a power supply capable of supplying 5 V at 2 A is required.
2.2.2
Load #1
A 10-V (or above), 2-A (or above) electronic load that can operate in constant current mode.
2.2.3
Load #2
A 10-V (or above), 2-A (or above) electronic load that can operate in constant voltage mode or a source
meter to simulate a battery.
meter to simulate a battery.
3
SLUU453B – November 2010 – Revised September 2012
bq24153A/56A/57/58/59 Fully Integrated, Switch-Mode, One-Cell, Li-Ion
Charger With Full USB Compliance and USB-OTG Support EVM
Copyright © 2010–2012, Texas Instruments Incorporated