Texas Instruments TPS2456 Dual 12V Protection and Blocking ORing Controller Evaluation Module TPS2456EVM TPS2456EVM 데이터 시트
제품 코드
TPS2456EVM
LOAD 1
POWER
SUPPLY 1
+V
GND
+12V
GND
LOAD 2
+V
GND
POWER
SUPPLY 2
+12V
GND
LOAD 1
POWER
SUPPLY 1
+V
GND
+12V
GND
LOAD 2
+V
GND
GND
+12V
GND
+12V
Setup
www.ti.com
3.2
Alternate Configurations
Figure 2. Dual Channel
Jumper Configurations:
J20 and J22 Jump to enable the retry on fault option for each respective channel. Leave open to latch
channel off on fault.
J20 and J22 Jump to enable the retry on fault option for each respective channel. Leave open to latch
channel off on fault.
J24 and J25: leave open to enable the OR-ing transistors. The OR-ing transistors are not required for this
application, but are installed on the board; and therefore, must be enabled. J10 jump pin 1 to pin 2 (Each).
Each channel has individual peak current limit.
application, but are installed on the board; and therefore, must be enabled. J10 jump pin 1 to pin 2 (Each).
Each channel has individual peak current limit.
Figure 3. Two Protected Loads
Jumper configurations:
J20 and J22 Jump to enable the retry on fault option for each respective channel. Leave open to latch
channel off on fault.
J20 and J22 Jump to enable the retry on fault option for each respective channel. Leave open to latch
channel off on fault.
J24 and J25: leave open to enable the OR-ing transistors. The OR-ing transistors are not required for this
application, but are installed on the board; and therefore, must be enabled.
application, but are installed on the board; and therefore, must be enabled.
J10 jump pin 1 to pin 2 (Each). Each channel has individual peak current limit which protects the loads
from overcurrent. The input supply must be capable of providing current equal to 2 times the current limit
of a single channel. If the input power source rather than the loads needs to be protected from overcurrent
then jump pin 2 to pin 3 on J10 (Total). The total current draw from the input power supply is limited to the
peak current limit.
from overcurrent. The input supply must be capable of providing current equal to 2 times the current limit
of a single channel. If the input power source rather than the loads needs to be protected from overcurrent
then jump pin 2 to pin 3 on J10 (Total). The total current draw from the input power supply is limited to the
peak current limit.
4
TPS2456EVM
SLVU368 – March 2010
Copyright © 2010, Texas Instruments Incorporated