Texas Instruments SD387EVK Evaluation Board SD387EVK/NOPB SD387EVK/NOPB 데이터 시트
제품 코드
SD387EVK/NOPB
SPA Dongle Description
The SPA dongle is required to use the SPI interactive GUI. The SPA dongle connects between the LMH0387 SPI
pins and the USB input of a PC. The SPA dongle is shown in Figure 2. JP7 is the SPI Header. The SPA dongle is
powered through the USB, and the D1 LED is RED when the SPA dongle is connected to a PC via the USB to
indicate the board is powered.
pins and the USB input of a PC. The SPA dongle is shown in Figure 2. JP7 is the SPI Header. The SPA dongle is
powered through the USB, and the D1 LED is RED when the SPA dongle is connected to a PC via the USB to
indicate the board is powered.
FIGURE 2. SPA Dongle
Figure 3 shows the connection between the SD387 and the SPA dongle. For proper operation, the SPI pins must
be connected between the SD387 JP1 and the SPA dongle JP7. Optionally, a single wire may be connected
between the SD387 TX_EN pin (JP2) and the SPA dongle PA0 (J7) to enable software control of the LMH0387
cable driver enable functionality, and allow the GUI to fully control the LMH0387 I/O Mode as described on page 8.
If this connection is not used, then the TX_EN can be controlled manually with a jumper.
FIGURE 3. SD387 Connection to SPA Dongle
SD387EVK User Guide
4 of 23
Rev 1.1
© 2010 National Semiconductor Corp.