Texas Instruments DAC8560EVM-PDK - DAC8560 Performance Demonstration Kit DAC8560EVM-PDK DAC8560EVM-PDK 데이터 시트
제품 코드
DAC8560EVM-PDK
1
3
1
3
1
3
1
3
1
3
1
3
www.ti.com
EVM Operation
Table 6. Jumper Setting Functions (continued)
Jumper
Reference
Function
Position
For DAC8560EVM, the V
FB
is routed out to minimize the output error. Remove R1 and short W7 as
shown; then connect V
FB
and V
OUT
as close as possible to the load. The V
FB
signal will be routed to
J4-10.
W7
This is the default jumper position for DAC8560EVM when R1 is installed.
For DAC8560EVM, the V
FB
is routed out to minimize the output error. Remove R1 and short W7 as
shown then connect V
FB
and V
OUT
as close as possible to the load. The V
FB
signal will be routed to
J4-14.
This jumper position selects the adjustable +5-V reference to route to the V
REF
input of the DAC8560.
This is the default jumper position for DAC8560EVM because the +2.5-V internal reference is enabled
W8
by default.
This jumper position selects the +4-V reference to route to the V
REF
input of the DAC8560.
Disconnects the inverting input of the output operational amplifier, U2, from the gain resistor, R12.
W15
Connects the inverting input of the output operational amplifier, U2, to the gain resistor, R12, for gain
of 2 configuration.
of 2 configuration.
Legend:
Indicates the corresponding pins that are shorted or closed.
13
SLAU211A – March 2007 – Revised November 2009
DAC8560 Evaluation Module
Copyright © 2007–2009, Texas Instruments Incorporated