Texas Instruments TPA3110D2 Evaluation Module TPA3110D2EVM TPA3110D2EVM 데이터 시트
제품 코드
TPA3110D2EVM
www.ti.com
Operation
Table 3. TPA3110D2 Control Guide (continued)
Control
Function
Options
Notes
PBTL
Sets the amplifier in PBTL mode
Insert jumper to defeat PBTL
If PBTL jumper is removed (PBTL mode), the Left
mode and run in normal
outputs (OUTPL and OUTNL) as well as the Right
stereo BTL mode.
outputs (OUTPR and OUTNR) are synchronized
and in phase. This allows them to be connected
together before the reconstruction filter for PBTL
operations. For PBTL operation, connect the
OUTPL and OUTNL to each other and connect
the OUTPR and OUTNR to each other. This can
be done by shorting the two pins of the molex
connectors labeled LEFT and RIGHT.
and in phase. This allows them to be connected
together before the reconstruction filter for PBTL
operations. For PBTL operation, connect the
OUTPL and OUTNL to each other and connect
the OUTPR and OUTNR to each other. This can
be done by shorting the two pins of the molex
connectors labeled LEFT and RIGHT.
JP3, JP4, JP5,
Connects LC filters to outputs.
The LC filters are not installed in this version of
and JP6
the EVM. However, the inductors are shipped with
the EVM package. They can be installed and used
as normal reconstruction filters or to smooth the
audio waveforms for measurement. They can also
be used when driving resistive loads to simulate a
speaker load. This EVM is meant to demonstrate
filter-free operation with just a ferrite bead and
small capacitor for good EMI performance.
the EVM package. They can be installed and used
as normal reconstruction filters or to smooth the
audio waveforms for measurement. They can also
be used when driving resistive loads to simulate a
speaker load. This EVM is meant to demonstrate
filter-free operation with just a ferrite bead and
small capacitor for good EMI performance.
5
SLOU263A – July 2009 – Revised July 2010
TPA3110D2 EVM Audio Amplifier Evaluation Board
Copyright © 2009–2010, Texas Instruments Incorporated