Texas Instruments PCM3070RHBEVM-K Evaluation Module PCM3070RHBEVM-K PCM3070RHBEVM-K 데이터 시트

제품 코드
PCM3070RHBEVM-K
다운로드
페이지 37
EVM Overview
1
EVM Overview
1.1
Features
Full-featured evaluation board for the PCM3070 stereo audio codec
USB connection to personal computer (PC) provides power, control, and streaming audio data for easy
evaluation
Onboard microphone for ADC evaluation
Connection points for external control and digital audio signals for quick connection to other
circuits/input devices
The PCM3070EVM-K is a complete evaluation kit, which includes a universal serial bus (USB)-based
motherboard and evaluation software for use with a personal computer running the Microsoft Windows
®
operating system (Windows Win2000 or Windows XP).
1.2
Introduction
The PCM3070EVM is in the Texas Instruments (TI) modular EVM form factor, which allows direct
evaluation of the device performance and operating characteristics and eases software development and
system prototyping.
The PCM3070EVM-K is a complete evaluation/demonstration kit, which includes a USB-based
motherboard called the USB-MODEVM Interface board and evaluation software for use with a PC running
the Microsoft Windows operating systems.
The PCM3070EVM-K is operational with one USB cable connection to a PC. The USB connection
provides power, control, and streaming audio data to the EVM for reduced setup and configuration. The
EVM also allows external control signals, audio data, and power for advanced operation, which allows
prototyping and connection to the rest of the development or system evaluation.
2
EVM Description and Basics
This section provides information on the analog input and output, digital control, power, and general
connection of the PCM3070EVM-K .
2.1
PCM3070EVM-K Block Diagram
The PCM3070EVM-K consists of two separate circuit boards, the USB-MODEVM and the PCM3070EVM.
The USB-MODEVM is built around the TAS1020B streaming audio USB controller with an 8051-based
core. The motherboard features two positions for modular EVMs, or one double-wide serial modular EVM
can be installed. The PCM3070EVM is one of the double-wide modular EVMs that is designed to work
with the USB-MODEVM.
The simple diagram of
shows how the PCM3070EVM is connected to the USB-MODEVM. The
USB-MODEVM Interface board is intended to be used in USB mode, where control of the installed EVM is
accomplished using the onboard USB controller device. Provision is made, however, for driving all the
data buses ( I
2
C™, SPI™, I
2
S, etc.) externally. The source of these signals is controlled by SW2 on the
USB-MODEVM. See
for details on the switch settings.
The USB-MODEVM has two EVM positions that allow for the connection of two small evaluation modules
or one larger evaluation module. The PCM3070EVM is designed to fit over both of the smaller evaluation
module slots as shown in
3
SLAU331A – January 2011 – Revised October 2012
PCM3070EVM-K Evaluation Module
Copyright © 2011–2012, Texas Instruments Incorporated