Texas Instruments PCM3070RHBEVM-K Evaluation Module PCM3070RHBEVM-K PCM3070RHBEVM-K 데이터 시트
제품 코드
PCM3070RHBEVM-K
EVM Description and Basics
Table 2. List of Jumpers and Switches (continued)
Jumper
Default
Jumper Description
Position
W14
Installed
Connects SCLK for USB SPI.
W15
Installed
Connects RESET for USB RESET.
W16
Installed
Provides a means to measure IOVDD current.
W17
Installed
Provides a means to measure DVDD current.
W18
Installed
Provides a means to measure LDO in/HPVDD current.
W19
Installed
Provides a means to measure AVDD current.
W20
2-3
Selects LDOin/HPVDD +5-V regulator source.
W21
Installed
Connects IOVDD from the header block to the rest of the circuit.
W22
Removed
DC-couples IN2_L. Use when evaluating DC measurement feature for this pin.
W23
Removed
DC-couples IN2_R. Use when evaluating DC measurement feature for this pin.
SW1
I2C
When set to I2C, the I2C signals from P12/J12 are connected to the codec and SPI_SELECT is set low. When
set to SPI, the SPI signals from P12/J12 are connected to the codec and SPI_SELECT is pulled to IOVDD.
set to SPI, the SPI signals from P12/J12 are connected to the codec and SPI_SELECT is pulled to IOVDD.
SW2
LOW
When set to LOW, AVDD and DVDD are connected to +1.8 VA and +1.8 VD, respectively, and LDO_SELECT
is set low. When set to HI, AVDD, and DVDD are disconnected from other supplies and LDO_SELECT is
pulled to IOVDD.
is set low. When set to HI, AVDD, and DVDD are disconnected from other supplies and LDO_SELECT is
pulled to IOVDD.
2.3
Analog Signal Connections
2.3.1
Analog Inputs
The analog input sources can be applied directly to terminal blocks J2, J3, and J4 or input jacks J1 and
J5. The connection details can be found in
J5. The connection details can be found in
2.3.2
Analog Output
The analog outputs are available from terminal blocks J6 and J8 or output jacks J7, J9, and J10. Note that
J10 is provided for signal-to-noise ratio (SNR) measurements only. The connection details can be found in
J10 is provided for signal-to-noise ratio (SNR) measurements only. The connection details can be found in
2.4
Digital Signal Connections
The digital inputs and outputs of the EVM can be monitored through P12 and P22. If external signals need
to be connected to the EVM, digital inputs must be connected via J14 and J15 on the USB-MODEVM and
the SW2 switch must be changed accordingly (see
to be connected to the EVM, digital inputs must be connected via J14 and J15 on the USB-MODEVM and
the SW2 switch must be changed accordingly (see
). The connector details are available in
2.5
Power Connections
The PCM3070EVM can be powered independently when being used in stand-alone operation or by the
USB-MODEVM when it is plugged onto the motherboard.
USB-MODEVM when it is plugged onto the motherboard.
6
PCM3070EVM-K Evaluation Module
SLAU331A – January 2011 – Revised October 2012
Copyright © 2011–2012, Texas Instruments Incorporated