Texas Instruments MSP430F534x 48-Pin Target board only MSP-TS430RGZ48B MSP-TS430RGZ48B 데이터 시트
제품 코드
MSP-TS430RGZ48B
Connector J5
External power connector for DVCC.
Set jumper JP3 to "ext".
External power connector for DVCC.
Set jumper JP3 to "ext".
IMPORTANT NOTE:
Rev1.0 of the board does not have
connection from pin 4 of BOOTST to
pin 64 of MCU. To use BSL, these pins
should be connected by a wire.
Rev1.0 of the board does not have
connection from pin 4 of BOOTST to
pin 64 of MCU. To use BSL, these pins
should be connected by a wire.
Jumper JP2
Open to disconnect LED.
Open to disconnect LED.
D1
LED connected to P1.0
LED connected to P1.0
Orient Pin 1 of
MSP430 device
MSP430 device
Jumpers JP5 to JP10
-2 to debug in
Spy-Bi-Wire mode.
Close 2-3 to debug in
4-wire JTAG mode.
Close 2-3 to debug in
4-wire JTAG mode.
Close 1
Jumper JP4
For F524x devices, close.
For F522x, F523x and F525x devices,
close only if one power supply is
used for VCC and DVIO, and if VCC is
not higher then 1.98 V. Otherwise.
supply DVIO over J6.
Do not close if VCC > 1.98 V, as it
may damage the chip.
For F522x, F523x and F525x devices,
close only if one power supply is
used for VCC and DVIO, and if VCC is
not higher then 1.98 V. Otherwise.
supply DVIO over J6.
Do not close if VCC > 1.98 V, as it
may damage the chip.
Connector J6
External power connector
to supply DVIO
External power connector
to supply DVIO
MSP-TS430RGC64C
Figure B-38. MSP-TS430RGC64C Target Socket Module, PCB
87
SLAU278Q – May 2009 – Revised February 2014
Hardware
Copyright © 2009–2014, Texas Instruments Incorporated