Texas Instruments 430BOOST-CC110L 사용자 설명서

10.  Launch the ATC – BoosterStack Lite software. The GUI 

screen will appear, and a trace for hub-node temperature 
will appear.

IMPORTANT NOTE: The 

 is designed to comply with regulations in 

the following regions:
 

  Europe – ETSI (default)

 

  North America – FCC / IC

If the intended location of use is not within these regions, then you must 

fi rst 

check with local regulatory agencies to determine any permissions/license/etc. 
are required prior to operation.
See Disclaimers and Regulatory Information included with the kit for 
more information.
11a.  For use in 

Europe, skip to step 12.

11b.  For use in 

North America, follow these steps:

 

–   Plug just one 

LaunchPad

/

 USB cable into 

the computer.

 

–   Under “Logical Radio” select “1 A110LR09A, FCC”.

 

–   Click “Apply Confi guration Changes”, the change is 

stored in the fl ash memory.

 

–   Repeat this step for the remaining 

LaunchPad

/

 units (plugging only one in at a time).

 

–   Re-connect all 

LaunchPad

/

 assemblies 

to the computer.

12. 

 The 

 fi rmware IC’s are shipped by default as 

‘hub node’ (non-transmitting on startup) to satisfy regula-
tory requirements, and one 

 must be toggled 

to “sensor node” for pairing to occur. The following is a 
subset of the full instructions contained in the 

 Users Manual (see CD documentation folder).

 

 a) To toggle the 

 from hub to  sensor node, 

triple-click 

LaunchPad

 switch S2. The 

LaunchPad

 red 

LED will blink 3x to indicate successful change to 
‘sensor node’.

 

 b) Press “Discover Nodes” on the GUI, and then imme-
diately press and hold the sensor node “S2” switch for 
2 seconds.  When paired correctly, the sensor node will 
appear in the ‘paired nodes’ list. 
NOTE: The GUI display may ‘gray out’ for up to 10 
seconds while nodes are discovered, this is normal.

13.   To identify a particular node, click the “Green LED” check 

box on the paired nodes list to toggle the node LED.