Insys WLAN Bridge 11-02-01-06-03.001 사용자 설명서

Implementation and Configuration INSYS WLAN bridge 

15  

the PC can be reset to the previous IP address. The PC and the INSYS WLAN bridge can 
then be reconnected normally with the network. 
 
Note: 

At all events, avoid the LAN connection of the AccessPoints and the LAN 
connection of the INSYS WLAN bridge being connected to the same network. 
This will lead to bridging of the packets into the same network and to serious 
malfunctions in the network and subsequently also to serious problems with 
your system administrator. 

 
If the IP address has accidentally been adjusted and/or is not known, the INSYS WLAN 
bridge can also be reset to the factory settings without the web interface, using the 
RESET key. See Chap. 5.3. 

 

 
The status page displays the current state of the INSYS WLAN bridge .   
In detail, the following information is provided: 
Connected to SSID: 

SSID of the remote terminal (AccessPoint or another bridge in 
adhoc mode), to which the module has a connection 

HF channel: 

Currently used channel 

MAC address of the AP:  MAC address of the remote terminal (adhoc) or of the 

AccessPoint 

Data rate (Mbits/s): 

Currently reached data rate 

Signal power (%): 

Current quality of the received signal level – the signal should 
be more than 20%  

Own MAC address: 

MAC address of the INSYS WLAN bridge 

version 1.01 / 10.04