Thecus N199 1-bay NAS N199 전단
제품 코드
N199
Network Management
Use the Network menu to make network configuration settings as well as service
support settings.
support settings.
LAN Configuration
From the Network menu, choose LAN,
and the LAN Configuration screen
appears. This screen displays the
and the LAN Configuration screen
appears. This screen displays the
network parameters of the WAN
connection. You may change any of
connection. You may change any of
these items and press Apply to
confirm your settings. You can see a
confirm your settings. You can see a
description of each item in the
following table:
following table:
WAN Configuration
Item Description
Host name
Host name
Host name that identifies the N199 on the network.
Domain name
Specifies the domain name of the N199.
MAC Address
Display the WAN port MAC address.
Jumbo Frame Support
Enable or disable Jumbo Frame Support of the WAN interface on
your N199.
Connection Type
The LAN IP can be set to a Static IP, Dynamic IP, or PPPoE.
Static: Administrator has to enter IP, Netmask, Gateway, DNS
Server fields.
Dynamic: If there is already a DHCP server on your network,
Dynamic: If there is already a DHCP server on your network,
you can let the DHCP server assign an IP address to your N199.
NOTE: If this is set to Dynamic, but a DHCP server is not
detected on the LAN network, the IP address of the N199 will
reset to the default setting of 192.168.1.100.
PPPoE: The N199 can also support a direct connection to an
reset to the default setting of 192.168.1.100.
PPPoE: The N199 can also support a direct connection to an
ASDL modem through PPPoE. Once selected, you will need to
enter a User Name and Password.
User Name
Enter your user name for PPPoE connection. (PPPoE only)
Password
Enter your password for PPPoE connection. (PPPoE only)
IP
IP address of the WAN interface.
Network mask, which is generally: 255.255.255.0
Network mask, which is generally: 255.255.255.0
Netmask
DNS Server
DNS Server
Domain Name Service (DNS) server IP address.
IP Sharing Mode
When enabled, traffic on the LAN will be directed to the WAN.
Default is Disabled.
PPPoE Connect
Connect or disconnect from a PPPoE connection. (PPPoE only)
28
• Only use Jumbo Frame settings when operating in a Gigabit environment where
all other clients have Jumbo Frame Setting enabled.
• Enabling DHCP automatically turns on UPnP — See the Service Support
Screen.
• If you are only using the WAN port, we suggest that you disable IP Sharing
Mode. This will result in higher throughput.
• A correct DNS setting is vital to networks services, such as SMTP and NTP.
NOTE
WARNING
Most Fast Ethernet (10/100) Switches/Routers do not support Jumbo Frame and
you will not be able to connect to your N199 after Jumbo Frame is turned on. If this
happens, turn off the N199. Then, power on the N199 and immediately press and
you will not be able to connect to your N199 after Jumbo Frame is turned on. If this
happens, turn off the N199. Then, power on the N199 and immediately press and
hold the Reset button on the front of the unit for 10 seconds. This will reset your
network settings, password, and turn off Jumbo Frame Support.