Thecus 500GB 1-bay NAS N199_1050 전단

The N199 supports external eSATA 
hard disks with its eSATA port. Once 

an eSATA hard disk has been 
successfully mounted, the eSATA 
drive will be visible in the Disks 

Information screen, located under 
the Storage menu.  

 
To install an eSATA hard disk, follow 

the steps below: 
 

1.  Press the power button. The power off sequence will begin, and the N199 

will power off. 

 

2.  Plug the eSATA hard disk to the eSATA port on the N199. 

 

3.  Power on the N199 and login under the administrator account to enter the 

Web Administration Interface. 

 

4.  The eSATA hard disk will be visible in the Disk Information screen under 

hard disk slot 2. 

 
 

Installing an eSATA hard disk will erase all data on that disk. This data can not be 
recovered. Please ensure that all contents on the eSATA disk are backed up before 

installing into the N199. 

 

If you are using RAID 1, you can easily replace a damaged hard drive in the 
Thecus N199 while keeping your data secure with the system’s automatic data 

recovery.  

When a hard drive is damaged, its LED glows a steady red. If there is data in the 

RAID volume, the system LED also glows red and the system beeps. 

To replace a hard disk drive in the N199: 

 

1.  Remove two screws located on the back of the unit using a Philips 

screwdriver.  

 

2.  Unscrew four mounting screws. 

 

3.  Lift up the hard disk tray by pulling up the top panel of the N199. 

 

4.  Remove the damaged hard drive. 

 

5.  Carefully insert a standard 3.5” SATA hard disk into the tray, and secure 

the hard disk with screws from the included accessory pack. 

 

6.  Carefully lower the hard disk tray back into the N199.  

 

7.  After making sure the tray is in place and the connectors are aligned, 

secure the hard disk tray with screws.  

 

 
 

78