Thecus 2TB Storage Server N299 N299_2100 전단

Your N299 is designed for complete ease-of-use. To help you get started, the 
following chapter will help you get your N299 up and running in no time. Please 

read it carefully to prevent damaging your unit during installation. 

Before you begin, be sure to take the following precautions: 

 

1.  Read and understand the Safety Warnings outlined in the beginning of 

the manual. 

 

2.  If possible, wear an anti-static wrist strap during installation to prevent 

static discharge from damaging the sensitive electronic components on the 
N299. 

 

3.  Be careful not to use magnetized screwdrivers around the N299’s 

electronic components. 

 

4.  The N299 uses its chassis to dissipate heat. Please leave your N299 in a 

well-ventilated area to prevent overheating. 

The N299 supports standard 3.5” (SATA) hard disks. To install a hard disk into 
the N299, follow the steps below: 

 

1.  Remove two screws located on the back of the unit using a Philips 

screwdriver.  

 

2.  Unscrew four mounting screws. 

 

3.  Lift up the hard disk tray by pulling up the top panel of the N299. 

 

4.  Carefully insert a standard 3.5” SATA hard disk into the tray, and secure 

the hard disk with screws from the included accessory pack. 

 

5.  If you are installing two hard disks, please insert the second hard disk at 

the bottom of the tray and secure it with screws from the included 

accessory pack. 

 

6.  Carefully lower the hard disk tray back into the N299.  

 

7.  After making sure the tray is in place and the connectors are aligned, 

secure the hard disk tray with screws.  

 

 

If your hard disk was previously part of a RAID 1 array, it will automatically rebuild. 
If you replace all the drives with higher capacity drives, you need to go to the 

Administrator login and format the drives. 

 

 

 

 
 

12