Atmel Xplained Evaluation Board ATXMEGAA3BU-XPLD ATXMEGAA3BU-XPLD 데이터 시트
제품 코드
ATXMEGAA3BU-XPLD
Atmel AVR1935
5
8324B-AVR-09/11
4 Connecting the kit
4.1 USB power supply
Connect a USB cable between the board and a PC or a USB power supply to power
the kit. This is all that is needed. When power is applied the power/status LED will
light up in green.
the kit. This is all that is needed. When power is applied the power/status LED will
light up in green.
Do not power the board without having the jumper next to the USB connector or an
amperemeter mounted. Otherwise, the device may be damaged.
amperemeter mounted. Otherwise, the device may be damaged.
When connecting the Atmel XMEGA-A3BU Xplained to a PC, the operating system
will request a driver file for installing the serial communication driver. This driver file is
available in the zip-file associated with this document. The driver file supports both
32-bit and 64-bit versions of Windows
will request a driver file for installing the serial communication driver. This driver file is
available in the zip-file associated with this document. The driver file supports both
32-bit and 64-bit versions of Windows
®
XP and Windows
7. Driver installs are not
necessary on Linux
®
operating systems.
4.2 Atmel JTAGICE3
Figure 4-1. The 100mil JTAG adapter must be used to connect to the kit.
4.3 Atmel AVR ONE!
The AVR ONE! JTAG connector can be connected to the XMEGA-A3BU Xplained kit
with a standoff adapter (adapter is marked with "nr.1").
with a standoff adapter (adapter is marked with "nr.1").