Beurer PM 25 Heart rate monitor watch with chest strap Black-grey 673.05 데이터 시트
제품 코드
673.05
8
Putting on the chest strap
Tighten the chest strap with the elastic tension
belt. Adjust the length of the belt such that the
belt is snug, but neither too loose nor too tight.
Position the belt around the chest such that the
logo is facing outwards and in the correct posi-
tion directly over the breast bone. For men, the
chest belt should be located directly below the
pectoral muscles, for women, directly below the
breast.
belt. Adjust the length of the belt such that the
belt is snug, but neither too loose nor too tight.
Position the belt around the chest such that the
logo is facing outwards and in the correct posi-
tion directly over the breast bone. For men, the
chest belt should be located directly below the
pectoral muscles, for women, directly below the
breast.
Since optimal contact between the skin and the heart rate sensors
can not be created immediately, it may take some time until the
heart rate is measured and displayed. If necessary, alter the
position of the transmitter in order to achieve optimal contact.
Most of the time, sufficient contact is achieved through the
accumulation of sweat beneath the chest strap. You can,
however, also wet the contact points on the inside of the chest
strap. For this, lift the chest strap up from the skin slightly and wet
the two sensors with saliva, water or ECG gel (available at the
chemistry). The contact between the skin and chest strap may not
be interrupted also with greater movements of the thorax such as
during deep breathing. Significant chest chair can interfere with
and even prevent contact.
can not be created immediately, it may take some time until the
heart rate is measured and displayed. If necessary, alter the
position of the transmitter in order to achieve optimal contact.
Most of the time, sufficient contact is achieved through the
accumulation of sweat beneath the chest strap. You can,
however, also wet the contact points on the inside of the chest
strap. For this, lift the chest strap up from the skin slightly and wet
the two sensors with saliva, water or ECG gel (available at the
chemistry). The contact between the skin and chest strap may not
be interrupted also with greater movements of the thorax such as
during deep breathing. Significant chest chair can interfere with
and even prevent contact.
Put on the chest strap a few minutes before starting in order to
warm it up to body temperature and establish optimal contact.
warm it up to body temperature and establish optimal contact.