Mikroelektronika MikroE Development Kits MIKROE-1133 데이터 시트
제품 코드
MIKROE-1133
1. Introduction
GPS Click - L10 is an accessory board in
mikroBus™
form factor. It’s a compact solution
for adding GPS functionality to your device. It
features
features
Quectel®
L10,
high performance
MTK positioning engine. GPS Click - L10
communicates with target board through
UART or I
communicates with target board through
UART or I
2
C interface. Data can be acquired
using PC application through USB connection.
Board features connector compatible with
active and passive antennas. It can operate on
3.3V power supply only.
Board features connector compatible with
active and passive antennas. It can operate on
3.3V power supply only.
Once you have soldered the headers your
board is ready to be placed into desired
mikroBUS™ socket. Make sure to align the
cut in the lower-right part of the board
with the markings on the silkscreen at the
mikroBUS™ socket. If all of pins are aligned
board is ready to be placed into desired
mikroBUS™ socket. Make sure to align the
cut in the lower-right part of the board
with the markings on the silkscreen at the
mikroBUS™ socket. If all of pins are aligned
correctly, push the board all the way
into the socket.
3. Plugging the board in
2
3
2. Soldering the headers
1
4. Features and applications
GPS Click - L10 board with it’s
Quectel® L10
module supports 210 PRN channels, with
66 search channels and 22 simultaneous
tracking channels. It has low tracking power
consumption of 38mA, 4Mbit flash memory,
superior anti-jamming design, and up to 5Hz
update rate. Its ease of integration results
in fast time-to-market in a wide range
of automotive, consumer and industrial
applications.
66 search channels and 22 simultaneous
tracking channels. It has low tracking power
consumption of 38mA, 4Mbit flash memory,
superior anti-jamming design, and up to 5Hz
update rate. Its ease of integration results
in fast time-to-market in a wide range
of automotive, consumer and industrial
applications.
Turn the board upward again. Make sure
to align the headers so that they are
perpendicular to the board, then solder the
pins carefully.
to align the headers so that they are
perpendicular to the board, then solder the
pins carefully.
Turn the board upside down, so that
bottom side is facing you upwards. Place
shorter parts of the header pins in both
soldering pad locations.
bottom side is facing you upwards. Place
shorter parts of the header pins in both
soldering pad locations.
GPS
click
Before using your click board, make sure
to solder the provided 1x8 male headers
to both sides of the board. Two 1x8 male
headers are included with the board in
the package.
to solder the provided 1x8 male headers
to both sides of the board. Two 1x8 male
headers are included with the board in
the package.
click
BOARD
www.mikroe.com
GPS click L10 Manual
ver. 1.00
0 100000 019849
L10