Mikroelektronika MikroE Development Kits MIKROE-1434 데이터 시트

1. Introduction

Once you have soldered the headers your 
board is ready to be placed into desired 
mikroBUS

™

 socket. Make sure to align the 

cut in the lower-right part of the board 
with the markings on the silkscreen at 
the mikroBUS

™

 socket. If all of the pins are 

aligned correctly, push the board all 

the way into the socket. 

3. Plugging the board in

2

3

2. Soldering the headers

1

4. Essential features

Turn the board upward again. Make sure 
to align the headers so that they are 
perpendicular to the board, then solder the 
pins carefully.

Turn the board upside down so that 
bottom side is facing you upwards. 
Place shorter pins of the header into the 
appropriate soldering pads.

Before using your click

™

 board, make sure 

to solder 1x8 male headers to both left 
and right side of the board. Two 1x8 male 
headers are included with the board in 
the package.

click

BOARD

www.mikroe.com

RFid click Manual

ver. 1.00

0 100000 024140

RFid click

™

 is an accessory board in 

™

 form factor. It’s a compact and 

easy solution for adding RFid to your design. 
It features 

 13.56 MHz contactless 

transceiver as well as trace antenna. RFid 
click

™

 communicates with the target board 

microcontroller via 

™ 

UART (TX, 

RX), SPI (MISO, MOSI, SCK, CS) INT, RST, 
PWM and AN lines. The board is designed 
to use 3.3V power supply only. LED diode 
(GREEN) indicates the presence of power 
supply.

RFid 

click

RFid click

 ™

 with its 

IC is a RFid 

module with integrated transceiver for 
contactless applications. The board

contains 

dedicated internal frame controller and analog 
front end (AFE) for RF communications. It 
supports ISO/IEC 14443 type A and B, ISO/IEC 
15693 and ISO/IEC 18092 protocols (tags) as 
well as the detection, reading and writing of 
NFC forum type 1, 2, 3 and 4 tags.